Author Topic: WTB: driveshaft and final drive/rear axle for 1990 K100LT  (Read 2484 times)

Offline bobmusick

  • Motobrick Curious
  • Posts: 42
WTB: driveshaft and final drive/rear axle for 1990 K100LT
« on: May 18, 2021, 04:39:02 PM »
Splines on both are useable but pretty shot. U joint on shaft sticks a bit in middle. Replaced transmission and as I was putting it together I thought I could get away with reusing them but after further inspection I really rather not.

Really don't want to break the bank as I already wasn't planning on doing as much as I have, so let me know if you have either or both you're willing to part with.

Located near Buffalo, NY.
  • Buffalo, NY
  • 1990 K100LT

Offline The Mighty Gryphon

  • Administrator
  • ^ Quintessential Motobricker
  • Posts: 6857
Re: WTB: driveshaft and final drive/rear axle for 1990 K100LT
« Reply #1 on: May 18, 2021, 04:54:55 PM »
Bob, I would take down your phone number and email.  Let people contact you via private message.
  • In my garage in Marilla, NY
  • '91K100RS White/Blue
Current:
'91 K100RS16V "Moby Brick Too"

Past:
'94 K75RT "Ilsa, She Wolf of the SS"
'92 K100RS16V "Moby Brick" (RIP, deceased in a vehicular assault)
'94 K75S Special Edition Dakar Yellow "Cheetos"
'89 K100RS Special Edition "Special Ed"

Offline bobmusick

  • Motobrick Curious
  • Posts: 42
Re: WTB: driveshaft and final drive/rear axle for 1990 K100LT
« Reply #2 on: May 18, 2021, 04:57:15 PM »
done, thank you!
  • Buffalo, NY
  • 1990 K100LT

Tags: