Author Topic: CA Emissions, is it necessary?  (Read 3181 times)

Offline Supershooter

  • ^ Proficient Motobricker
  • Posts: 228
CA Emissions, is it necessary?
« on: February 29, 2020, 04:09:48 PM »
I’m refreshing my 85 K100, and have discovered it has the emissions hardware. Can I eliminate the emissions hardware or will I have issues getting the bike to run correctly?
Supershooter
  • Liberty Township, O'brien County, Iowa
  • 85 K100 RT

Offline Laitch

  • Faster than a speeding pullet
  • Administrator
  • ^ Quintessential Motobricker
  • Posts: 11299
Re: CA Emissions, is it necessary?
« Reply #1 on: February 29, 2020, 04:15:31 PM »
Which hardware is that—the tube connection from the tank to the crankcase that has the one-way valve?
  • Along the Ridley in Vermont.
  • 1995 K75 89,000 miles

Offline Supershooter

  • ^ Proficient Motobricker
  • Posts: 228
Re: CA Emissions, is it necessary?
« Reply #2 on: February 29, 2020, 04:29:56 PM »
That tube and the hardware that’s screwed to the back side of the throttle body.
  • Liberty Township, O'brien County, Iowa
  • 85 K100 RT

Offline volador

  • ^ Quintessential Motobricker
  • Posts: 1167
  • NEEDS MORE CHROME
Re: CA Emissions, is it necessary?
« Reply #3 on: February 29, 2020, 04:33:39 PM »
Plug off the tubing at cyl#1 and tape up the electrical connector to the harness somewhere. No longer needed
  • NYC NY
  • 1991 K100RS 1993 K75S ABS
5 BOROUGHS SISYPHEAN SOCIETY  MAINTAINING THE OBSESSION

Offline Laitch

  • Faster than a speeding pullet
  • Administrator
  • ^ Quintessential Motobricker
  • Posts: 11299
Re: CA Emissions, is it necessary?
« Reply #4 on: February 29, 2020, 04:47:45 PM »
That tube and the hardware that’s screwed to the back side of the throttle body.
You can cap that tube's port at the crankcase then run the tube from the tank port to exit behind the right footpeg plate. Alternatively you can install the BMW accumulator cup—16132307467—on the frame under the tank, run a hose from it to behind the peg plates and the ports can empty into it.

* accumulator cup.png (62.08 kB . 344x268 - viewed 335 times)


Regarding the vacuum switch: it was discontinued. Nobody seems to be complaining about missing its function. Just verify no vacuum leaks when you disconnect it.
  • Along the Ridley in Vermont.
  • 1995 K75 89,000 miles

Offline Supershooter

  • ^ Proficient Motobricker
  • Posts: 228
Re: CA Emissions, is it necessary?
« Reply #5 on: March 01, 2020, 10:16:17 AM »
Is the fitting in the block threaded?
  • Liberty Township, O'brien County, Iowa
  • 85 K100 RT

Offline volador

  • ^ Quintessential Motobricker
  • Posts: 1167
  • NEEDS MORE CHROME
Re: CA Emissions, is it necessary?
« Reply #6 on: March 01, 2020, 11:07:12 AM »
A piece of tubing at the front of the crankcase underneath the radiator shroud
your 85 K100 may or may not have the crankcase tubing due to the date of manufacture and when those emissions standards enacted



which is connected to a gray check valve via hose somewhere under petrol tank



which is connected to the forward tubing under the tank of the 2 tubings grouped together
the forward tube is the tank air vent
rear tube is the rain drain of the tank cap



remove the check valve and can use an accumulator cup under petrol tank which makes tank removal easier in the future or
connect long hoses to the rain drain and tank vent tubing
route downward along the backside of the right footpeg plate as above indicated
cap off the crankcase tubing however you deem suitable, a screw, a folded over piece of hose zip-tied, a golf tee

http://www.motobrick.com/index.php/topic,3653.msg21985.html#msg21985

https://forums.bmwmoa.org/showthread.php?4534-Why-is-the-85-K100-the-quot-Finest-Year-K-quot&s=a6655a3c79c7707c65cc85f6da573ee9
  • NYC NY
  • 1991 K100RS 1993 K75S ABS
5 BOROUGHS SISYPHEAN SOCIETY  MAINTAINING THE OBSESSION

Tags: