:falldown:Have attached pics of modification, very hard to get decent shot.I will try and explain installation you need to hunt around auto supply shops and get the smallest
switch possible. I believe I got mine from Autobarn,they let me go out and try switch under the side cover.Beside the switch you will also require two solder in cable lugs
and rubber boots.You then need to lift seat and pull tool box & brain out of the way. Disconnect the positive lead.The earth cable runs west to east horizontally at the west corner it then goes vertically down.On this corner this is where you need to cut out a small piece of cable, make sure you get it right.If you get it wrong you will need a new cable.You need to allow room for the switch and the lugs.Orientate the lugs to the switch, then slide on some shrink wrap & boots first & solder in the lugs.Install the switch
I went a bit overboard and put a rubber disc of insertion rubber to make sure the boot did not wear through and allow the isolator connection to come in contact with the positive terminal of the battery.Once you are happy cable tie everything neatly in position and reconnect the positive. The switch can only just be seen, if you painted the
removable red piece it would be virtually be invisible.I take no responsibility it you undertake this modification. It worked well for me but everybody is different .
Merry Xmas Martin
