For sale - Brass K75 exhaust bushings

[K_grendell]

Are these the bushings that seal between the muffler and exhaust collector? If so are any more available I need one for my k75s.

[bocutter Ed]

Are these the bushings that seal between the muffler and exhaust collector? If so are any more available I need one for my k75s.

Yes. There is one left from the initial prototype run of, IIRC, 22 units. I picked up enough tubing to make at least 100 pieces.

[K_grendell]

Thanks Ed I just sent you a pm.

[stokester]

Yes. There is one left from the initial prototype run of, IIRC, 22 units. I picked up enough tubing to make at least 100 pieces.

Good news.
Put me in line for two.

[bocutter Ed]

Thanks Ed I just sent you a pm.

I notice you have a PX200 in your sig. Does that take the same graphite-pressed-on-steel-mesh gasket/bush as the modern 250 & 300 models?

[bocutter Ed]

Good news.
Put me in line for two.

Carp. I'm going to have to get my arse in gear then.

[K_grendell]

Ed I don’t believe it does. It’s been a while since I rebuilt the motor so I’m going from memory. The modern ones are four stroke, mine is a a 2t and the exhaust slides over the header stub and gets held down on with two springs to seal it up. Did you receive my pm?

[Laitch]

Carp.

[bocutter Ed]

Did you receive my pm?

Yes, and replied.