Bike: 1985 K100RS, 48k miles
Disclaimer: I am fairly mechanically-inclined, but I have never owned or worked on a K bike before, or any other bike with fuel injection
My K100 was unused for at least 3 years before I bought it and brought it home on a trailer. I dumped out the old gas and added a few gallons of new fuel and a shot of Techron. I cleaned the plugs and installed a new battery. After cranking for a bit I finally got it to fire after turning the throttle back a ways. It ran extremely rough as if it were only running on a couple cylinders. I did a few start / run / stop cycles and it seemed to smooth out a wee bit, but would not idle. After shutting it off I took a small paintbrush, dipped it in water and used it to test the temperature of the header pipes. Cylinders 1 & 2 hissed and steamed off immediately but #3 and #4 were cold.
What's the next logical step here? Is there a DIY approach for cleaning injectors that I should attempt?