Tried to remove the clutch-plate by prying with a nail remover and realized I was prying from the outside and needed to pry from the center out :loco: Do you guys think that I damaged the plate at all? I read that these plates are real sensitive, just don't want any additional vibration because of this screw up. It was mainly behind the Front Pressure Plate Springs. I didn't apply too much pressure but I did feel some movement. Hope I didn't warp it any.
Also while pulling off the transmission had to wiggle a bit and am wondering if I may have bent the clutch rod, doesn't appear bent but I noticed there was definitely some play in the hole where it came from. Probably normal? I pulled the transmission with my elbows resting on my knees, but it didn't come out perfectly straight which is why I ask.
