« previous next »
Pages: [1]   Go Down

Author Topic: Disconnecting temp sensor connnector  (Read 3642 times)

Offline Jtoregan

  • Curious
  • Posts: 8
Disconnecting temp sensor connnector
« on: November 12, 2024, 02:12:55 PM »

* 20241112_120859.jpg (42.2 kB . 768x576 - viewed 312 times)

Noob here. I am trying to get my frame off the engine, but I can't get this plug out, and I'm worried I'm going to break it. Any pointers?
Logged
  • Denver
  • '87 K100

Offline frankenduck

  • Adrninistrator
  • ^ Quintessential Motobricker
  • Posts: 5511
Re: Disconnecting temp sensor connector
« Reply #1 on: November 12, 2024, 02:24:50 PM »
That's the wire for the temp sensor for the temp gauge. Not related to Hall Sensor. It just pulls apart. Wiggling the two pieces helps.



Logged
Once I had a Collie pup. Dug a hole and covered him up. Now I sit there by the hour. Waiting for a Collie-flower.
New to K bikes? Click here.
K Bike Maintenance & Mods: Click here.
Buy parts here.

Offline Jtoregan

  • Curious
  • Posts: 8
Re: Disconnecting temp sensor connector
« Reply #2 on: November 12, 2024, 02:44:25 PM »
Those side tabs don't need to be pushed in?
Logged
  • Denver
  • '87 K100

Offline Jtoregan

  • Curious
  • Posts: 8
Re: Disconnecting temp sensor connector
« Reply #3 on: November 12, 2024, 03:08:17 PM »
Never mind, that worked! Thanks so much
Logged
  • Denver
  • '87 K100

Offline Jtoregan

  • Curious
  • Posts: 8
Re: Disconnecting Hall unit
« Reply #4 on: November 13, 2024, 01:25:03 PM »

* 20241113_112246.jpg (48.15 kB . 768x576 - viewed 286 times)

Now this plug that runs along the temperature sensor is stuck. It Wiggles a bit, but won't come out. Any pointers?
Logged
  • Denver
  • '87 K100
Pages: [1]   Go Up
« previous next »
Tags: