MOTOBRICK.COM

TECHNICAL MOTOBRICK WRENCHING In Remembrance of Inge K. => The Motobrick Workshop => Topic started by: Filmcamera on September 26, 2016, 10:54:38 AM

Title: Fuel pressure regulator mounting screws
Post by: Filmcamera on September 26, 2016, 10:54:38 AM

The fuel pressure regulator on my 1991 K100 RS 16v ABS was just sitting on top of the engine behind the not connected to anything.

After some searching I found out where it is supposed to fit

(http://fuelli10.png)

I looked on Max BMW to see what screws I need to attach it but they don't show a part number (nor do they show the mount as far as I can see)

Anyone know the type and size I need to reattach it?

Title: Re: Fuel pressure regulator mounting screws
Post by: Inge K. on September 26, 2016, 11:29:15 AM

The bracket for the FPR is mounted on TB bridge (existing screws is used), and sold together as one part.
The FPR is mounted to bracket with a fine thread nut M12x1,5mm.

Title: Re: Fuel pressure regulator mounting screws
Post by: Filmcamera on September 26, 2016, 11:38:22 AM

Quote

The bracket for the FPR is mounted on TB bridge (existing screws is used), and sold together as one part.

 I do have the bracket - it is attached to the FPR - but the screws in the TB bridge are not there - it is the size and type of them I need.

Title: Re: Fuel pressure regulator mounting screws
Post by: Inge K. on September 26, 2016, 11:47:06 AM

Remove one from the center bracket and measure it........I would guess M6x15/20.