MOTOBRICK.COM

TECHNICAL MOTOBRICK WRENCHING In Remembrance of Inge K. => The Motobrick Workshop => Topic started by: bizzaro on August 21, 2016, 06:14:00 PM

Title: C O adjustment screw on a 94 K11LT?
Post by: bizzaro on August 21, 2016, 06:14:00 PM

For the life of me I could not find anything remotely like the C O  adjustment screw in the photos in my Clymer, or the illustration in  my BMW repair manual.  Man I looked real long and hard.  Notta?  I am guessing it has been superseded by technology in my 94 K11 and is adjusted by the computers in the motronic etc? Is there an adjustment screw, and if so, where is it?  I am trying to lean out my mix to the cylinders.

Title: Re: C O adjustment screw on a 94 K11LT?
Post by: Inge K. on August 21, 2016, 06:19:01 PM

The CO adjustement screw is on the non cat models only....if you have a cat you don't find that pot meter
on your bike.......think I did read somewhere that only cat models was sold in the US.

Title: Re: C O adjustment screw on a 94 K11LT?
Post by: bizzaro on August 21, 2016, 07:20:44 PM

Thanks Inge.......................Yep,That splains it, I gots the cat!   And niether my clymer or beemer manual says jack shit about adjusting the C O with a cat. I can't find anything on it here or anywhere else for that matter.  :musicboohoo: DAMN

Title: Re: C O adjustment screw on a 94 K11LT?
Post by: Inge K. on August 22, 2016, 02:29:58 AM

Quote from: bizzaro on August 21, 2016, 07:20:44 PM

And niether my clymer or beemer manual says jack shit about adjusting the C O with a cat.

On cat models the Motronic unit takes care of that, based on the signal from the lambda sensor.

Title: Re: C O adjustment screw on a 94 K11LT?
Post by: bizzaro on August 22, 2016, 08:13:18 AM

Yea, that was my assumption, thanks for the confirmation,