MOTOBRICK.COM

MOTOBRICK MARKETPLACE => FS WTB WTT ~ Bikes ~ Parts ~ Gear => Topic started by: Torquepen on June 11, 2015, 08:42:30 AM

Title: K75 gearbox output shaft wanted
Post by: Torquepen on June 11, 2015, 08:42:30 AM

Does anyone have an old K75 output shaft for sale? I need the clutch end splines to be pretty good but not worried about the state of the internal cogs at all. I need to make a clutch alignment tool so need it straight.
I'm in West Sussex UK & could do with this asap. And cheap!
T

Title: Re: K75 gearbox output shaft wanted
Post by: peter_in_the_bay on June 11, 2015, 05:27:24 PM

Hello,
Just my humble newbie observation but if you need it fast check out this video from the BMW Motorrad Club of Northern Illinois. They use a makeshift adjustment tool at 20:15. This is what I am going to try unless there are some objections. Hope it helps.
https://www.youtube.com/watch?v=BcXbHxSj3sI

Title: K75 gearbox output shaft wanted
Post by: Torquepen on June 11, 2015, 05:52:53 PM

Thanks Pete but I'm fitting a different engine altogether to the gearbox & bike. The alignment tool is to help drill multiple holes in new metalwork [emoji6]

No longer needed!