MOTOBRICK.COM

TECHNICAL MOTOBRICK WRENCHING In Remembrance of Inge K. => The Motobrick Workshop => Topic started by: wimke on March 05, 2014, 03:41:46 AM

Title: K100 ignition switch
Post by: wimke on March 05, 2014, 03:41:46 AM: Hi is it possible to use a universal ignition switch on my K100 if yes can some one please help me with witch wire goes where.
By the way ST is de starter function on the switch. hope some one can help me out here thanks :yow :bmwsmile
Title: Re: K100 ignition switch
Post by: Scott_ on March 05, 2014, 07:02:23 AM: Looking at the schematic of the stock switch, I'd say 'most likely not'.
The stock switch is a static 3 position, what I mean by that is that there is no "spring loaded start" selection like in your car/truck.
The generic should have; off(static),on(static),start(momentary).
Your stock should be; off(static), park(static), Ign(static).
Title: Re: K100 ignition switch
Post by: TimTyler on March 05, 2014, 12:57:18 PM: Some more good info at http://www.motobrick.com/index.php?topic=3888.0 (http://www.motobrick.com/index.php?topic=3888.0)
Title: Re: K100 ignition switch
Post by: wimke on March 05, 2014, 03:52:50 PM: Dus als ik het oude contactslot loskoppel heb ik een rode , groene , blauw witte en een grijze draad

Red = Batt?
green = IGN?
blue/gray = where does this one go???
gray = ACC ? parking light?

Correct me if im wrong but did i put the wires in the right position or am i going all wrong??????

:2thumbup:
Title: Re: K100 ignition switch
Post by: Inge K. on March 05, 2014, 06:33:54 PM: Red = Batt? OK
green = IGN? OK
blue/gray = From light switch, connect to gray wire.
gray = To tail/park, connect to blue/gray wire.
Title: Re: K100 ignition switch
Post by: wimke on March 08, 2014, 03:16:41 PM: Quote from: Inge K. on March 05, 2014, 06:33:54 PM
Red = Batt? OK
green = IGN? OK
blue/gray = From light switch, connect to gray wire.
gray = To tail/park, connect to blue/gray wire.

Thanks for the help it works great ;-)

:bmwsmile :2thumbup: