MOTOBRICK.COM

TECHNICAL MOTOBRICK WRENCHING In Remembrance of Inge K. => The Motobrick Workshop => Topic started by: georgethegoat on September 21, 2012, 11:19:27 PM

Title: K75 ABS rear brake slave cylinder exploded diagram?
Post by: georgethegoat on September 21, 2012, 11:19:27 PM

Anyone got an exploded diagram of this?

I'm talking about the little pump just to the rear of the rear brake pedal... (I think that's called the slave cylinder -- although I'd be amenable to another name since the master/slave comparison seems a little expired  :giggles)

Anyway I ordered a rebuild kit for it since it is leaking. I'm assuming it'll be a couple hour project at most but then again I couldn't figure out that my clutch was slipping because there was no slack in the cable. So all bets are off.

So, who's got a diagram?

Shanksh  :2thumbup:

Title: Re: K75 ABS rear brake slave cylinder exploded diagram?
Post by: georgethegoat on September 22, 2012, 03:13:27 PM

Nevermind,

Found one  :deal: http://www.maxbmwmotorcycles.com/fiche/DiagramsMain.aspx?vid=51739 (http://www.maxbmwmotorcycles.com/fiche/DiagramsMain.aspx?vid=51739)

Also I guess I meant the master cylinder.

Wee  :bmwsmile