MOTOBRICK.COM

TECHNICAL MOTOBRICK WRENCHING In Remembrance of Inge K. => Project Custom Motobricks => Topic started by: digger2 on September 18, 2025, 08:51:31 PM

Title: Footpeg mounts
Post by: digger2 on September 18, 2025, 08:51:31 PM

I am looking for ideas to replace the factory peg mounts with something less bulky, any suggestions welcome

Title: Re: Footpeg mounts
Post by: Kaos on September 27, 2025, 01:56:42 AM

Well, are you in for a treat.
Whats the budget?
There are quite a few "custom brick part" vendors that offer sets. But do keep in mind that it wont be the cheapest

Title: Re: Footpeg mounts
Post by: digger2 on September 28, 2025, 02:45:36 PM

Budget is pretty open for the right stuff, not looking for rearsets though. I know that e bay /amazon peg sets for a multistrada will fit in a pinch

Title: Re: Footpeg mounts
Post by: Kaos on September 29, 2025, 05:07:36 PM

Solely replacing the mounting plates pretty much leaves you with the interchangeable plates for your model. There are some variants.
Also there have been quite a few people that have made them less bulky themselves with the use of an angle grinder.
The Rearset itself would be easier. And then id also recommend the suppliers that cnc them themselves instead of Asian sourced variants as mostly found on Amazon or eBay. And they are k model specific.