MOTOBRICK.COM
TECHNICAL MOTOBRICK WRENCHING In Remembrance of Inge K. => The Motobrick Workshop => Topic started by: alexg on May 04, 2022, 05:21:17 PM
-
Hi all:
I bought a hyper-light brake light kit and it requires a hot with ignition power source. Any recommendations where is more convenient?
Thanks
-
Green/black wire of the connector for the rear brake switch. (Under right side cover.)
Or white nylon connector in the relay box - green/brown wire.
-
That works. My bike has ABS, can I tap from the computer? Shorter run to the rear light. Thanks !
-
If you want to tap near the rear then tail light power - gray/black.
-
Of course, rear position light is always on! Thanks !!!
-
Installed the two 8-LED modules to the side of the regular brake light. Looks like it was designed that way. I am very happy. Tapped all the needed connections at the rear light as well. Thanks for the suggestions.
-
Photos? And where did you source your lights?
-
Photo as requested. It is annoying to look at! Bought it from Sierra BMW in Reno, Nv.
-
Hi Alex, very nice!
this ones?
https://hyperlites.com/?product=u32-kit
-
That brand, but the ones with only 8 LEDs per side. I cannot confirm that the 16 LEDs will fit in the space.
-
Do you have a link?
-
https://hyperlites.com/?product=universal-kit
It is in the same site, just a few clicks away. Cheaper too.
-
Txs Alex!
good find