MOTOBRICK.COM

TECHNICAL MOTOBRICK WRENCHING In Remembrance of Inge K. => The Motobrick Workshop => Topic started by: GaryFrank on August 10, 2019, 01:55:13 PM

Title: Raising a K100
Post by: GaryFrank on August 10, 2019, 01:55:13 PM

Other than changing the front forks or manufacturing new tubes, is there any other way of raising a K100?
Back end is pretty straight forward, just have to watch the driveshaft angle

Title: Re: Raising a K100
Post by: johnny on August 10, 2019, 02:49:21 PM

terex (https://www.terex.com/cranes/en/)

Title: Re: Raising a K100
Post by: GaryFrank on August 10, 2019, 02:57:36 PM

😂😂😂 not exactly what I was going for.....

I’m a bit long in the leg (my other ride is an Africa Twin) and would ride to get some distance between the tar and my butt

Title: Re: Raising a K100
Post by: johnny on August 10, 2019, 03:05:50 PM

greetings...

getts another set of fork tubes... swedge the new tubes so the existing tubes slide up in there... cut them to desired height... slide them into the tree...

j o