MOTOBRICK.COM

TECHNICAL MOTOBRICK WRENCHING In Remembrance of Inge K. => The Motobrick Workshop => Topic started by: jonb on October 24, 2011, 09:17:43 PM

Title: Converting low seat height to regular seat height (1987 K100RS)
Post by: jonb on October 24, 2011, 09:17:43 PM

I may have the opportunity to get the necessary hardware to convert my low seat height to a normal seat height.  Along with the side panels, seat, and the hardware shown in the fiche below, is there anything else that's required?  Any funky grommets needed for the side panels?

(http://i.imgur.com/UDDak.png)

Title: Re: Converting low seat height to regular seat height (1987 K100RS)
Post by: frankenduck on October 24, 2011, 09:41:00 PM

Start by looking at the correct fiche.  What you posted is for an 85.

Title: Re: Converting low seat height to regular seat height (1987 K100RS)
Post by: jonb on October 24, 2011, 11:23:03 PM

Thanks, I thought that all the normal seat heights were the same and was too lazy to read the descriptions on the fiche.  The seat is for an '85 and would require its tailpiece as well to fit on my bike so I'll give it a miss.