MOTOBRICK.COM
TECHNICAL MOTOBRICK WRENCHING In Remembrance of Inge K. => The Motobrick Workshop => Topic started by: K1300S on August 07, 2018, 12:46:35 PM
-
my attempts at searching the depth of the internet have failed.
looking for a pinout diagram for the K1100RS (1996) Motronic ECU connector. we have a no start issue and i need to wring out the engine harness for continuity to make sure wire aren't broke somewhere...
anyone have a link to where i could find the diagram?
thanks!
-
greetings...
i gotts it at home on mines laptop... butts thats days away...
will this getts you by... i think itsa 93 2.2...
http://www.motobrick.com/index.php/topic,7996.0.html
j o
-
do you have a Clymer manual?
The wiring diagrams in rear, pages 706 and 707, state 94 and on.
they are not the best/easiest to trace but may give you a start.
-
greetings...
i gotts it at home on mines laptop... butts thats days away...
will this getts you by... i think itsa 93 2.2...
http://www.motobrick.com/index.php/topic,7996.0.html
j o
J o...thanks! page 2 of that doc has some of the pinouts we can start with.
do you have a Clymer manual?
The wiring diagrams in rear, pages 706 and 707, state 94 and on.
they are not the best/easiest to trace but may give you a start.
have all the manuals. those are just the general wiring diagrams for the bike. i need the specific pinout numbers/functions of the motronic harness connector, which are not in the manuals.
-
Try these, 1 page of the input pin-outs, 1 page of output pin-outs, and 2 pages of legend id's.
-
Try these, 1 page of the input pin-outs, 1 page of output pin-outs, and 2 pages of legend id's.
awesome! thanks Scott!