MOTOBRICK.COM

TECHNICAL MOTOBRICK WRENCHING In Remembrance of Inge K. => The Motobrick Workshop => Topic started by: Tuco on November 25, 2017, 10:59:04 PM

Title: Driveshafts?
Post by: Tuco on November 25, 2017, 10:59:04 PM

My old 87 K100 LT has given up its final drive splines/ driveshaft at 96,000 miles. I've found a decent priced final drive, splines look good. Now I need a driveline. My question is are all the mono lever drivelines the same 20 spline units.Asking because I found a nice unit out of a K75 but am unsure if K75 driveline will fit.  I know the 1985 drivelines are 16 spline. Other than that I think the the K75 driveline should fit, but not 100% sure. Anybody know?

Title: Re: Driveshafts?
Post by: Inge K. on November 25, 2017, 11:31:18 PM

Quote from: Tuco on November 25, 2017, 10:59:04 PM

Other than that I think the the K75 driveline should fit, but not 100% sure. Anybody know?

Yes, same part number....according to the online parts manuals.

Title: Re: Driveshafts?
Post by: Billk on November 26, 2017, 12:11:41 PM

Can you direct me to which parts line manual you’re using,
thank you

Title: Re: Driveshafts?
Post by: Laitch on November 26, 2017, 12:50:57 PM

Quote from: Billk on November 26, 2017, 12:11:41 PM

Can you direct me to which parts line manual you’re using,
thank you

Try this one (http://www.maxbmwmotorcycles.com/fiche/PartsFiche.aspx) to compare part numbers among various models.